Lighting your gas fireplace is very important to be able to experience the heat and splendor they can provide. Different from a conventional wood burning up fire place, a gas fireplace is commonly self-starting. Unlike an electric powered fireplace, a gas fireplace requires use of a pilot light to be able to fire up, similar to water heater or a gas stove.
Try looking in your fire place to see if you see a small flame, which is called the pilot light. If you don’t see this flame, then you have to first light up the pilot before you can fire up your gas fire place.
In case you have an attractive front panel or grill on your gas fireplace, at all times remove it before lighting your pilot.
Your own valves might be positioned behind a panel. In that case, locate this particular panel and open it up in order to access your valves and controls.
Ensure all of your controls are off and the pilot really is shut off.
Check to make certain that the control valve and main gas valve are switched off. If the main gas valve or control valve is on, turn it off and wait around around 5 minutes to allow just about any gas to clear just before you proceed. These types of vital actions will help you prevent incidents with your gas fire place. Remove any kind of interior glass doors if you haven’t already done this.
Smell throughout the fire place to be certain that there is no gas present that may catch fire while you switch on the pilot. Be sure you sniff around close to the floor as the gas is more heavy as opposed to the surrounding air. If there is, permit the fireplace to air out not less than 5 minutes just before you carry on. If the gas smell does not clear and you’ve checked once more to be certain that all valves are turned off, you’ll want to contact an installer to ascertain if there are leaks.
If there is no gas smell present, switch the main valve on and the control valve to pilot. Press the control valve in approximately one fourth of an inch as you are turning. If you cannot press the control valve inward using only your own hand, phone a qualified technician. Don’t use any items to attempt to push the control valve. Forcing the valve isn’t only a fire hazard, but might also trigger explosion.
Hold the pilot valve in not less than 15 seconds but up to 30 seconds and hit the piezoelectric spark igniter repeatedly in an interval of once for every second in order to turn the pilot light on. When the pilot light is turned on, a tiny flame should appear. If the pilot light won’t remain on after repeated attempts, contact a qualified technician.
Press the pilot valve in for 60 seconds or so in order to heat up your thermopile. When the thermopile has been warmed up, your burner will power up. As soon as burner is activated, switch the control valve to on and modify the thermostat to your chosen configurations. The thermostat control might be a turn in the bottom panel, a standard light switch, dimmer, or it may be started using a remote control.
Change the inner glass door, any bottom access panel, attractive glass panel or grill and make sure it is properly clamped to the front of your respective fire place. Enjoy your fire place!